Change and maintain the order of catalogs

Change and maintain the order of catalogs

You can reorder any catalog under the catalog browser with drag and drop operation, but restarting IRONCAD will not retain reordering.
This can be accomplished by adjusting the order with the “Catalog Sets” command.



Procedure:

[1] Select the [Common]tab → [Catalogs]group → [Catalog Sets].


[2] After select the [Default Scene], Click [Edit].

​
[3] Select the catalog files you want to change the order and adjust them in [Move Up] and [Move Down] botton.

Close all catalogs at once in the Common tab → Catalog Group → Catalog Set.


[5] When you open the "Catalog Sets" again, the reordered catalogs will be displayed.

Please refer to the video below.


Ic-030

    • Related Articles

    • [Allow Reordering] Setting

      In IRONCAD, the parts you create retain a history of operations in a tree structure. If the setting [Default Reordering Settings] under 3D [Options] is set to [Always Allow Intellishape Reordering] or [Use Part Reordering Setting], the program may ...

    • Change the order of items in the catalog

      Explain how to change the order in the catalog for elements registered in the catalog (parts/assembly/feature). Procesure: [1] Register the items in the catalog. If you are already registered, no. [2] Press and hold the Shift key to drag the ...

    • Change imported aluminum frame to data that can change length

      Imported aluminum frame data cannot be used to change the length. Becase it is one-block(Brep). Imported data is loaded as parts that cannot be edited when imported on IRONCAD. If you want to change the length of aluminum frame data for intermediate ...

    • Change Snap Increments in TriBall

      Explain how to change snap increments when moving or rotating axially in TriBall. It can be moved and rotated in the specified increment. When moving and rotating, it can prevent it from becoming a half-point value. Procedures [1] Place any part in ...

    • Edit catalog item

      Explain how to edit the registered catalog item. IRONCAD catalog can be reused by registering various shapes, features, colors, etc. Registered items can be edited later. Procedures [1] Right-click the catalog item, click [Edit Catalog Item]. [2] The ...