Copy the base point of 2D data and push it out

Copy the base point of 2D data and push it out

Learn how to copy the base point of 2D data and paste it into a 3D scene for extrusion.
The operation procedure is as follows:

[1] Select the 2D shape.

[2] Click the Drawing tab → Edit Group → Copy Base Point and select the base point.

[3] Create a sketch in a 3D scene.

[4] Right-click on the sketch screen, select Paste, and paste the 2D shape.
After placing the shape, if the connection point is red, right-click at the connection point and connect.

[5] After the connection,Click to finish the sketch.

[6] Select the cross-sectional shape and right-click.

[7] Click Create → Extrude from the menu.

[8] Set the extrusion distance.

Click OK to apply the command.

For more information, please refer to the video below.


Ic-089

    • Related Articles

    • Mirror copy shapes (parts, holes, blocks, etc.)

      Explain how to mirror the shape. Target object: Parts Features (holes, blocks, etc.) Assembly There are two ways to "Mirror" operation. Mirror Feature command [1] Set the "Selection Filter" in the lower right corner of the IRONCAD screen to ...

    • Create a base table that can change height

      Explain how to create a base table that can be easily changed height using placement restraints and parameters. Design time can also be reduced by registering catalogs and diverting them to other facilities. Please refer to the video below. from ...

    • Simplify your data with "Shrink Wrap" function

      The "Shrink wrap" function simplifies the entire data and some selected elements. Simplified data and original data are linked. By switching and using it improve the comfort of operation. Application You want to reduce data capacity You want to ...

    • Mirror copy the Body of the structure part

      Learn how to mirror the Body of a structure part. Procedures Select the [1] Feature tab → Mirror. If you want to mirror the Body of a structure part, TriBall cannot. [2] Select the structure part to run Mirror. If the structure part is set to Active, ...

    • Basic operation of Attachment Point

      "Attachment Point" function is used to define junction points against shapes, parts, assemblies, etc. and to connect them with other objects. Insert "Attachment Point" Select the parts and click "Attachment Point" on the Tools tab. If you click on ...