Create a rectangular pyramid

Create a rectangular pyramid

[Shape] Catalog [PyramidsThen you can create a pyramid.
However, rectangular pyramids cannot be created.

Rectangular pyramids can be created in the Extrusion Wizard.
The operation procedure is as follows:

[1] Create a block in the Feature tab → Feature Group → Extrusion Wizard.

[2] [Feature] tab → [Feature] group → [ Extrusion], it creates a sketch so that the front of the block created in [1] is triangular, and select [Delete Material]. After click [OK].

[3] Temporarily suppress the [Extrude] created in [2].

[4] [2] Create a sketch so that the side of the block created in [1] becomes a triangle and select [Remove Material].
After click [OK].
[5] Release the "Suppress" of [3].

For more information, please refer to the video below.

from IC-014

    • Related Articles

    • Create Broken View

      Procedures: [1] Click "Broken View" and select the projection view you want to create. [2] Select the type from item 1 of the status bar. zigzag/curve/line [3] Specify on two ranges to omit (start and end). ※Several can be created [4] Right-click to ...

    • Create partial fillet shape

      Explain how to create a partial fillet using "Cut Extrude". Procedures: [1] Drag and drop "Cut Extrude" on the Shape catalog at the center of the part edge. [2] Adjust the extrusion direction with TriBall to parallel to the edge. (Tune the arrows of ...

    • Create fan-shaped model

      Fan-shaped models can be created in the Spin Wizard or Extrusion Wizard. In case of Spin Wizard [1] Click "Spin Wizard" on the Feature tab. [2] Select Plane Type, then draw sketch. Create a sketch with the Y axis pointing upward. Then click "Finish" ...

    • Create a chuck opening and closing action

      Explain how to create a chuck movement to grab the workpiece. Even if the number of chuck points or more, if it is the same opening and closing operation, you can create a movement by copying one chuck in a circular array. Please refer to the ...

    • Create "Chamfer" dimensions for tilted parts

      Explain how to create chamfer dimensions (C style) of tilted parts. Auxiliary View can be created in the same way. Procedure: [1] Click "Chamfer" on the Annotation tab. [2] Set the instance menu items at the bottom left of the screen. 1: Default ...