Create an assembly disassembly state

You can explode an assembly using [Assemble Explode Tool] in the [Tools] catalog.

Exploded information is added to the parts in the exploded file and cannot be removed.
If you plan to register the parts in a catalog for reuse, please use the original, non-exploded parts.

Please refer to the video below.
IC-047

• Related Articles

• Project 3D models into CAXA Draft in disassembly

  This section explains how to switch between assembled and exploded views when projecting to CAXA Draft. To project an exploded view, first create a [Configurations] of the exploded state in the 3D model. Reference: Display Configuration is reflected ...

• Set Insert Joint Point and create continuous pipes and mounts

  This section explains how to use the [Attachment Point] function to build continuous pipe structures or equipment base frames in IRONCAD. In piping design and equipment base structures, it is common to use multiple sections of the same type of round ...

• Create a detailed diagram

  This section explains how to create a [Detail View] by enlarging a specific area of a projection drawing in CAXA Draft. A detail view improves the clarity of drawing information by enlarging areas where lines overlap and make dimensioning difficult, ...

• Create a hatch to a diagram projected from 3D

  This section explains how to apply custom hatching patterns to each part in a projected view created from 3D data in CAXA Draft. Procedure: [1] Click [Standard View], then move [Options] tab. Set the [Hatch Settings] for each part or assembly. After ...

• Create a part number (balloon) in a 2D diagram

  This section explains how to create item numbers in CAXA Draft what infomation gotted from 3D data. To create part numbers based on 3D information, you must first perform [Import 3D Parts List]. 3D and linked - IRONCAD User's Guide Use [Create Item ...