Create a part number (balloon) in a 2D diagram
This section explains how to create item numbers in CAXA Draft what infomation gotted from 3D data.
To create part numbers based on 3D information, you must first perform [Import 3D Parts List].
Use [Create Item No. automatically] or [Manual Generate Item No.] in the [3D Interface] tab.
There are two methods: Auto and Manual.
For easier placement and editing, we recommend using [Manual Generated Item No.].
Please refer to the video below.
CA-032
Related Articles
Re-import BOM message appears when creating Item No. (balloon)
When outputting an assembly as a part in the CAXA Draft, if you see a re-import message for the part list, the following causes may be considered: "Include this shape in BOM" of 3D Properties is not checked. It is set to "Treat as part" in the ...Change the Frame Type of Part Numbers
This section explains how to change the shape of part numbers. Part number shapes are configured in the Bill of Materials (BOM) input screen. Procedure: [1] After projecting the drawing, click [Import 3D BOM] in the [3D Interface] tab. Since part ...Grouping part numbers (balloons)
Item numbers (balloons) can be grouped. Procedures: [1] Create a item number with [Manual Generate item No.] on the [3D Interface] tab. [2] Select the Item Numbers you want to group on the BOM list. [3] Click on the item number created in [1] to ...Create a detailed diagram
This section explains how to create a [Detail View] by enlarging a specific area of a projection drawing in CAXA Draft. A detail view improves the clarity of drawing information by enlarging areas where lines overlap and make dimensioning difficult, ...Create a hatch to a diagram projected from 3D
This section explains how to apply custom hatching patterns to each part in a projected view created from 3D data in CAXA Draft. Procedure: [1] Click [Standard View], then move [Options] tab. Set the [Hatch Settings] for each part or assembly. After ...