Create a detailed diagram

Create a detailed diagram

This section explains how to create a [Detail View] by enlarging a specific area of a projection drawing in CAXA Draft.


A detail view improves the clarity of drawing information by enlarging areas where lines overlap and make dimensioning difficult, or where the arrangement of parts is visually unclear in the overall projection view.


Please refer to the video below.

CA-029

    • Related Articles

    • Editing Centerlines After Creating a Broken View

      This section explains how to edit centerlines after creating a broken view in CAXA Draft. Procedure: [1] Select the broken view, right-click, and click [View edit]. After creating a breakout view, you cannot edit the centerline by double-clicking the ...

    • Create Broken View

      Procedures: [1] Click "Broken View" and select the projection view you want to create. [2] Select the type from item 1 of the status bar. zigzag/curve/line [3] Specify on two ranges to omit (start and end). ※Several can be created [4] Right-click to ...

    • Create Dimensions on an Isometric View

      This section explains how to create dimensions on an isometric view exported from a 3D scene. If the Isometric View Has Not Yet Been Created In the following steps, make settings and create dimensions: [1] Open CAXA Draft, then go to [Menu] → ...

    • Create Hatching in a Projected View

      This section explains how to create manual Hatching in a projected view that is linked to a 3D drawing, independent of Section View. Procedure: [1] Right-click on the projected view and select [View Edit] or [View Edit In-place] to enter the ...

    • Select the Front View definition in Scene

      You can pre-set the front view definition to the 3D Scene when projecting on CAXA Draft and 2D drawing. Explain how to define a front view. Right-click Parts/Assembly and click Define Front View in 3D. Valid settings for CAXA Draft and 2D Drawing ...