Create annotations on drawings

In 2D drawings, notes are used to provide supplementary information for manufactured parts that may be difficult for others to interpret based solely on the drawing, dimensions, or symbols.

This section explains how to create drawing notes in CAXA Draft.

To create any note, click [Technique Requirement Library] in the [Annotation] tab.

Please refer to the video below.

CA-031

• Related Articles

• Creating a Block (CAXA Draft)

  This section explains how to create Block parts in CAXA Draft. Block parts allow you to register frequently used lines or shapes as blocks so that they can be easily inserted into drawings. By registering items such as bolts, pins, and annotations as ...

• Create multiple drawings in different sheets on one exb file

  This section explains how to create multiple drawings within a single CAXA drawing file (.exb) by using separate sheets. Procedure: [1] Open the existing CAXA draft (.exb) file. [2] In the [Model] sheet, right-click and select [Insert]. [3] A new ...

• Set Insert Joint Point and create continuous pipes and mounts

  This section explains how to use the [Attachment Point] function to build continuous pipe structures or equipment base frames in IRONCAD. In piping design and equipment base structures, it is common to use multiple sections of the same type of round ...

• Create CAXA Draft Frame Title Field Template

  Learn how to create a template file that works with the property information of the 3D model. Types of Templates There are three types of CAXA Draft templates. Title column template (.chd) You can register the title field. Frame Template (.cfm) Only ...

• Change the standard for 2D drawings

  Set-Standard (JIS, ANSI, GB) can be changed. It can also be changed if the standard applied to the template you create are wrong. When you change the standard, the tolerances and each symbol on the [Dimensions] tab will change. ※It applies from newly ...