Part selection or SmartDimension is not available when using the status bar section view
Published: October 29, 2025
Situation: Improved
Target Products and Versions
IronCAD 2025
Content of the defect
When using the cross-sectional view in the status bar, "Part selection cannot be selected" and "SmartDimension cannot be used" phenomena occur.
With a cross-sectional view, SmartDimension does not allow you to use the forbidden mark even if you match the mouse cursor to the surface, point, etc.
In cross-section view, you cannot select parts or IntelliShapes in the scene.
As shown in the figure below, you cannot select them.
How to deal
Apply the IRONCAD 2025 cumulative update.
IRONCAD 2025 Cumulative Update