IRONCAD Displays in English After Installation

After installing IRONCAD, you may find that the software launches with the English interface instead of Japanese.

Factors:

The Japanese Language Pack for IRONCAD is not installed.

The registry setting for the language is set to 0.

[1] In the Windows search box, type [Control Panel] and open it.

[2] Select [Program].

[3] Click [Uninstall a Program].

[4] Make sure IronCAD 20×× PU1 JA-JP Language Pack(×64) is installed.

If it is not installed, proceed to Step 5.

If it is already installed, skip to the section [Registry Setting is Set to 0] below.

[5] On the installation media drive, navigate to the following folder:

Installation media drive: \x64\package\LangPack\ja-jp

[6] Run [IC_LangPack_Setup_x64.exe] in the folder.

Security software may interfere with the installation. If possible, temporarily disable security software before proceeding.

[1] In the Windows search box, type [regedit] and launch the [Registry Editor].

[2] In the Registry Editor, navigate to the following path:

HKEY_CURRENT_USER\Software\IronCAD\IRONCAD <Version>\General\Current Language

※The <Version> in IRONCAD corresponds as follows:

The IronCAD version is as follows:

Ironcad 2023 is Ironcad 25.0

Ironcad 2024 is Ironcad 26.0

Ironcad 2025 is Ironcad 27.0

[3] Double-click [Current Language].

[4] Check the value under Value data.

If it is set to 0, change it to [411].

The language setting values are as follows:

0: English

411: Japanese