Move the Position of 2D Sketch drawing

Move the Position of 2D Sketch drawing

When creating 3D shape, you may first create a sketch.
Sketch shapes can be freely drawn, and you may need to move the drawn figures afterward.
There are three ways to move a sketch figure. Below are the methods for each:
  1. After selecting the shape, go to the [Sketch] tab → [Modify] group → use the [Move] command.
  2. After selecting the shape, right-click keep drag and move.
  3. Use the TriBall to move the shape.
Please refer to the video below.

IC-048

    • Related Articles

    • Create a spin shape (solid) by X axis or Y axis standard of the sketch.

      Use the [Spin Wizard] to create a spin shape. Create a spin shape by the Y axis of the sketch [1] Click [Spin Wizard] on the [Feature] tab. [2] Select "Plane Type" from the property and click [OK]. (If there is no shape on the scene, it will ...

    • Reflect and refer to other dimensional values in sketch dimensions

      *IRONCAD 2024 New Features Explain how to reflect or refer to other dimensional values in SmartDimension created in a 3D sketch. It is effective when creating shapes that change regularly. Can't apply to cross-sectional shapes of standard catalog ...

    • Create a Twisted Shape

      This section explains how to create a twisted shape using [Loft] in the [Feature] tab. Procedure: [1] Create Sketch. then copy at the "TriBall". And set position each sketch. [2] Click [Loft] in the [Feature] tab. [3] Select all sketches. [4] Click ...

    • Create partial fillet shape

      Explain how to create a partial fillet using "Cut Extrude". Procedures: [1] Drag and drop "Cut Extrude" on the Shape catalog at the center of the part edge. [2] Adjust the extrusion direction with TriBall to parallel to the edge. (Tune the arrows of ...

    • Create a rectangular pyramid shape

      You can usually create a pyramid shape using [Pyramid] in the [Shape] Catalog. However, rectangular pyramid cannot be created. Rectangular pyramid can be created in the [Extrude Wizard] on the [Feature] tab. Procedures: [1] Create a block using ...