Set the length of the center line

Set the length of the center line

Learn how to set the length of the center line in CAXA Draft.
The length of the center line can be changed with optional settings.
The setup procedure is as follows:

Select [1] Menu → Options.


Change the value of [2] [3D interface] → [centerline extension].


[Set unit] is set to include the scale of the drawing.
If checked, the length will change according to Sheet Units.
If it is not checked, it will remain the length of the set value regardless of the scale.
<下図はチェック有りの場合の例>
Notes
If the scale is 1:2, twice the set value.


If the scale is 2:1 ... half of the set value

Warning
Settings are reflected from the projected projection diagram after the setting change.
It is not reflected for projections that have already been projected.


    • Related Articles

    • Create Center Line of Circle Array

      This section explains how to create circular centerlines. It is used when you want to create centerlines pointing toward the center of a pitch circle, especially for multiple holes arranged in a circular pattern. Procedure: [1] Click [Center Line of ...

    • Create the center line of arc long holes

      Since the center line of arc long holes is not created automatically, we will explain how to create it manually. "Center Line of Circle Array" command on the "Common" tab. Procedures: [1] Double-click the projection diagram, move to the block's place ...

    • It changes line type of some parts.

      It changes line type of some In the 2D assembly drawing, in addition to the main design data, it want to may be expressed in line types (imagination lines) other than solid lines. Using the 3D Configuration function, it can project to be divided into ...

    • Change the length of the line by specifying the extension direction (IRONCAD/Setch Mode)

      This section explains how to change the length of a line in a specified direction during a 3D sketch in IRONCAD. Procedure: [1] In the sketching screen, use [Polyline] to draw a horizontal straight line. [2] Create dimensions using [SmartDimension]. ...

    • Change the Drawing Scale of a Projection View

      This section explains how to set the scale for projection views in 2D Draft (CAXA Draft). New creating View Procedure: [1] Click [Standard View] in the [3D Interface] tab. [2] The [Export Standard View] dialog will appear. In the bottom-right corner, ...