Recent Articles
Parts from Different Standards Appear in Created Piping
Applicable Product and Version: IRONCAD 2025 Cause: Normally, piping created using a selected standard cannot have parts from a different standard attached. However, in rare cases, parts from another standard may appear in the piping. These parts ...
Fittings Such as Elbows or Cross Joints Remain and Cannot Be Deleted
Applicable Product and Version: IRONCAD 2025 Cause: During pipe creation, a phenomenon has been observed where, after adding or deleting components, only the fitting parts (such as elbows or cross joints) remain by themselves. If a 3D curve remains, ...
Setting Loft Continuity: [Start Magnitude / End Magnitude]
When adding a loft to the edges of an existing surface or solid, you can set the continuity using Start Magnitude and End Magnitude. Procedure: [1] Prepare the existing loft shape. [2] On the Surface tab, click [Loft Surface]. When creating an ...
Creating an Assembly Feature: Extruded Cut
Use Assembly Feature → Extruded Cut to create consecutive holes in multiple parts within an assembly with a single feature. Procedure: [1] In the Assembly tab, click [Assembly Feature Exclude Remove]. [2] Create the sketch for the cut shape. [3] In ...
Moving a View from an Arbitrary Base Point by Stretch
This section explains how to move a projected view from any chosen base point in CAXA Draft. Procedure: [1] On the Drawing tab, click [Stretch]. [2] In the Instance Menu at the lower-left of the screen, set Item 1 to [Select by window] and Item 2 ...
IronCAD is available for purchase in ASEAN region.