Create geometric tolerances

This section explains how to create geometric tolerances in a drawing created with CAXA Draft.

Geometric tolerances can be added from the [Annotation] tab → [Annotation] group.

Please refer to the video below.

CA-027

• Related Articles

• Set Insert Joint Point and create continuous pipes and mounts

  This section explains how to use the [Attachment Point] function to build continuous pipe structures or equipment base frames in IRONCAD. In piping design and equipment base structures, it is common to use multiple sections of the same type of round ...

• Creating a Block (CAXA Draft)

  This section explains how to create Block parts in CAXA Draft. Block parts allow you to register frequently used lines or shapes as blocks so that they can be easily inserted into drawings. By registering items such as bolts, pins, and annotations as ...

• Create an automatic list

  This section explains how to create an [Auto list] as shown in the figure below, using CAXA Draft. Procedure: [1] Click [Create User Coordinate] in the [View] tab. Then you create coordinate system. [2] Click [Auto List] in the [Annotation] tab. [3] ...

• Create annotations on drawings

  In 2D drawings, notes are used to provide supplementary information for manufactured parts that may be difficult for others to interpret based solely on the drawing, dimensions, or symbols. This section explains how to create drawing notes in CAXA ...

• Create a twisted shape

  This section explains how to create a twisted shape using [Loft] in the [Feature] tab. Procedure: [1] Create Sketch. then copy at the "TriBall". And set position each sketch. [2] Click [Loft] in the [Feature] tab. [3] Select all sketches. [4] Click ...