Unable to Insert Fillet on 3D Curves

Unable to Insert Fillet on 3D Curves

When applying [Fillet/Chamfer] to 3D curves, it may not work properly if the curve segments are too short.

Solution:

[1] Draw the 3D curves with longer lengths.
[2] Apply the fillet.
[3] Trim or shorten the extended 3D curves as needed.

Please refer to the video below.

IC-087

    • Related Articles

    • Unable to create "Assemble" on the externally linked part side

      After saving some parts from the assembly scene with an external link, open the externally linked parts separately. Within a single external link part, you cannot create an assembly. Causes Example: Open externally linked parts separately from the ...

    • Unable to Import Point Cloud Files

      Point cloud files typically use extensions such as .PTS and .PTX. If the import into IRONCAD fails, please try the following steps: Solution: [1] Open 3D Options Settings, enable [Full Multi-Threading (needed for Point Cloud)] in the [Rendering] ...

    • Replacing the Server PC

      This section outlines the procedure for replacing the server PC. Operations on the Old Server PC [1] Shut down the Network License Manager (NLM). Refer to Step 1–2 of the NLM Restart Manual for details. Reference: NLM Restart - IRONCAD User's Guide ...

    • Model Does Not Appear in the Scene

      When opening a file, if parts or assemblies are listed in the [Scene Browser] but no model is visible in the scene, the following causes may be suspected: The data was not loaded properly The scene file is corrupted Solution: Before proceeding, ...

    • Checking Firewall Port Numbers for IRONCAD

      IRONCAD's network license (CU) uses a red USB dongle connected to the license server. Launch NLM - IRONCAD User's Guide To allow client PCs to connect properly, the port numbers preconfigured in IRONCAD must be opened on the server's firewall. Port ...