Parts
Create a round bar with a 3D curve (create a curved round bar)
After creating lines with "3D Curve", it will explain how to create a round stick with "Sweep". The following actions are based on IRONCAD 2022 and later versions: Prior to IRONCAD 2021, the command placement is different, but the operation method is ...
"Ctrl + E" key - change the display of edges
Since IRONCAD 2022, the switch operation of the edges display of the part has changed. Older versions (and earlier IRONCAD 2021) return to the original part state by pressing the Ctrl + E key twice. After IRONCAD 2022 has added "Shaded" pattern. ...
Create a fan model
Fan-shaped models can be created in the Spin Wizard or Extrusion Wizard. The operation procedure is as follows: How to create in the Spin Wizard [1] Run the Feature tab → Feature Group → Spin Wizard and draw a rectangle. [2] Double-click the corner ...
Create a rectangular pyramid
[Shape] Catalog [PyramidsThen you can create a pyramid. However, rectangular pyramids cannot be created. Rectangular pyramids can be created in the Extrusion Wizard. The operation procedure is as follows: [1] Create a block in the Feature tab → ...
Create grooves with sweeps on cylindrical sides
The cylindrical shape explains how to create a groove through which the cam passes. The groove is created vertically towards the center of the cylinder. Procedures [1] Create guidelines wrapped in cylindrical shapes. [2] Create a cross-sectional ...
Copy the base point of 2D data and push it out
Learn how to copy the base point of 2D data and paste it into a 3D scene for extrusion. The operation procedure is as follows: [1] Select the 2D shape. [2] Click the Drawing tab → Edit Group → Copy Base Point and select the base point. [3] Create a ...
Reflect and refer to other dimensional values in sketch dimensions
*IRONCAD 2024 New Features Explain how to reflect or refer to other dimensional values in SmartDimension created in a 3D sketch. It is effective when creating shapes that change regularly. Can't apply to cross-sectional shapes of standard catalog ...
Fix the twist of loft shape
When creating loft, the shape may be twisted. It will explain how to deal with that case. Procesures 〔1〕 Right-click of Loft, Click "Edit Match Points". 〔2〕 Click on a number to see a red dot. (Match Point) Drag and drop to fix the position. 〔3〕 The ...